Connecting Devices - Gioteck EX1-RT Instruction Manual

CONNECTING DEVICES

To use the headset for the first time you must
pair it with a Bluetooth® enabled device.
1. Ensure the headset is within 1 meter of the device.
2. Activate Bluetooth on the device (Settings >Bluetooth > ON)
3. With the EX1-RT Off, hold the Power button for 3 secs until
all the LED's illuminate to a solid state.
4. Select 'EX1-RT' from the list of Bluetooth devices,
or select 'Scan for new devices'.
5. If the device asks for a passcode, enter four zeros (0000).
6. The LEDs will flash every 3 seconds once pairing is successful.
[Voice Prompt: Pairing Successful] [Voice Prompt: Phone Connected]
The headset will now connect to your device automatically.
If pairing is not completed within 2 minutes the headset will
turn off. If this happens, please repeat the pairing process.
The headset will turn off automatically
after 10 minutes of inactivity.
MULTI-CONNECTION TO 2 DEVICES
Follow the instructions above to pair the EX1-RT to 2 devices.
Switch the headset off and on again, and it will connect to
both devices automatically. When the headset is turned on,
it will connect to the last device you were connected to.
STREAMING AUDIO
Audio will stream automatically once the EX1-RT is wirelessly
connected to a device. Streaming will pause during an
incoming/outgoing call and resume when the call ends.
[Voice Prompt: Pairing ]