Gioteck EX1-RT Instruction Manual page 10

LEGAL
This product complies with the following legal regulations.
For further information go to www.gioteck.com
This device complies with Industry
Canada RSS 210 standard(s).
Operation is subject to the following
two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Gioteck hereby declares that
this product is in compliance
with the essential requirements
and other provisions of Directive
2004/108/EC and R&TTe 1999/5/
EC. To view the full version of the
Declaration of Conformity please
go online to doc.gioteck.com
Caution: The user is cautioned that
changes or modifications not expressly
approved by the party responsible
for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may
cause undesired operation. Note:
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant
to part 15 of the FCC Rules.These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment
into an outlet on a circuit
different from that to which
the receiver is connected.
• Consult the dealer or
an experienced radio/
TV technician for help.
This equipment complies with FCC
radiation exposure limits set forth
for an uncontrolled environment.
End user must follow the specific
operating instructions for satisfying
RF exposure compliance. This
transmitter must not be co-located
or operating in conjunction with any
other antenna or transmitter.