Table of Contents
Advertisement
The full firmware update deletes the old firmware, downloads the latest firmware and installs it on the
eZLO hub. This update does not affect the eZLO data and settings.
To make a full firmware update:
1. Make sure that the eZLO ethernet cable and DC power cables are connected to the eZLO hub
and that it is switched ON.
2. Press and hold down the Reset button on the back of the eZLO hub.
3. Disconnect the eZLO hub from its DC power source.
4. (The button marked 9 in
5. Reinsert the DC cable into the eZLO hub while keeping the Reset button pressed down.
6. When the eZLO backlight LED becomes a solid yellow release the Reset button.
5. When the E rror Indicator and M essage Indicator LEDs (the 5th and 6th LEDs) blink quickly, give
a single, short press on the Reset button.
The eZLO backlight LED blinks green three times and one time yellow, or inversely.
6. Wait as the eZLO hub reboots and the Full Firmware Update is completed.
At this point the eZLO hub should become connected to the server, and the R eady Indicator LED
turn yellow.
F igure 1 eZLO Hub
) .
47
Advertisement
Table of Contents
