DREAMS KIMBERLEY BED Assembly Instructions

Assembly Instructions

Minimum No. of people

Recommended to assemble

This product.

Approx assembly time:

NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that

the bed will be used in.

Before you

Start, here

is some

helpful advice

KIMBERLEY BED

1. We suggest you spend a short time reading through this leaflet and then follow

the simple step by step instructions.

2. If you follow the instructions carefully the end result should be worth the effort.

3. Do not discard any of the packaging until you have checked that you

have all the parts and the pack of fittings.

4. Assemble this product on a carpet.

5. To ensure an easier assembly, we strongly advise that all fittings are only

finger tightened during initial assembly. Only upon completion of the assembly

should all fixing points be fully tightened.

6. We recommend a periodic check on all fixing points to make sure they remain

fully tightened.

7. Keep glue and fittings out of children's reach.

In the unlikely event that this product has missing or damaged parts, please call

to obtain spares

1 of 5

Table of Contents

Need help?

Do you have a question about the KIMBERLEY BED and is the answer not in the manual?

Page 1 KIMBERLEY BED Assembly Instructions Minimum No. of people Recommended to assemble This product. Approx assembly time: NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that the bed will be used in.
Page 2 Component parts and fittings contained in the box PARTS Fittings Connector 8pcs Connecting bolt 8pcs 1 piece M8 Nut 8pcs 2 pieces 8 Spring washer 8pcs Dowel 4pcs M6 x 35 Bolt 6pcs 1piece M6 x 22 Jcn Nut 6pcs Spanner 4MM Allen key 2 of 5...
Page 3 ASSEMBLY STEP 1 Screw the connecting bolt (B) into the headboard (1) and footboard (2). 1) Knock the dowels (E) into the holes STEP 2 indicated on the side rail (3). 2) Carefully fit the side Frames to the headboard and footboard. Use connectors (A), Spring Washer (D) and Nuts (C) to fix the unit.
Page 4 ASSEMBLY NOTE: STEP 3 Slats not supplied shown for reference only. Both slats on “step 3---step 6” can be assembled to the bedstead. you can to make a choice between the two slats. 1) Adjust the support leg height have the four mode, you can according to the bed height, choice the right mode to fix in the “STEP 3”.
Page 5 ASSEMBLY STEP 5 1) Carefully locate the slats frame onto the bed. 2) Use bolt ( ) and JCN Nut ( ) to fix the slats frame onto the bed. STEP 6 1) Carefully locate the slats frame onto the bed. 2) Use bolt ( ) and JCN Nut ( ) to fix the...

Kimberley