Advertisement
KINGSBURY BED
Assembly Instruction
Minimum No.of people
recommended to assemble
this product
Approx assembly time
Before you
start,here
is some
helpful advice
SMALL DOUBLE 234-00000 (Solid slats)
DOUBLE
KING
1.
We suggest you spend a short time reading through this leaflet and
then follow the simple step by step instructions.
2.
If you follow the instructions carefully the end result should be worth
the effort.
3.
Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
4.
To ensure an easier assembly, we strongly advise that all fittings are
only finger tightened during initial assembly. Only upon completion of
the. Assembly should all fixing points be fully tightened.
5.
We recommend a periodic check on all fixing points to make sure they
remain fully tightened.
6.
Keep glue and fittings out of children's reach.
7.
In the unlikely event that this product has missing or damaged parts,
please call 0844 292 0000 to obtain spares
Page 1 of 6
234-00001 (Sprung slats)
231-00027 (Solid slats)
231-00028 (Sprung slats)
235-00027 (Solid slats)
235-00128 (Sprung slats)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DREAMS KINGSBURY BED
Summary of Contents for DREAMS KINGSBURY BED
- Page 1 SMALL DOUBLE 234-00000 (Solid slats) 234-00001 (Sprung slats) DOUBLE 231-00027 (Solid slats) 231-00028 (Sprung slats) KING 235-00027 (Solid slats) KINGSBURY BED 235-00128 (Sprung slats) Assembly Instruction Minimum No.of people recommended to assemble this product Approx assembly time Before you We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
- Page 2 PARTS Fittings M8 x 20mm x 8pcs. 1(1 piece) Ø3.5 x 25mm x 2pcs. 4(1 piece) 3(2 pieces) Allen key 4mm x 2pcs. M6 x 38mm x 6pcs. 5(2 pieces) 2(1 piece) M6 x 22mm x 4pcs. Ø4 x 40mm x 6pcs. M6 x 6pcs.
- Page 3 Assembly Fix the side rails "3" to the headboard "1" and footboard "2". Use bolts "A", tighten using allen key "C". Attach central support "4" to support feet "5". Use bolts "D", tighten using allen key "C". Page 3 of 6...
- Page 4 Place the fixed central support "4" onto the support block on headboard "1" and footboard "2". Fix the central support "4" at both ends using screws "B", tighten with a screwdriver. IMPORTANT Once the feet have been assembled and attached, they should be adjusted to ensure they do not touch the floor, (7mm above the...
- Page 5 Fix the slats at both ends and the middle using screws "F" and washers "G", tighten with a screwdriver. total of six screws and washers. Option 2: Dreams sprung slat frame Open the metal slat frame outwards. Page 5 of 6...
- Page 6 Turn the metal slat frame falling upward and carefully lower the slat frame into the bed. Ensure that the frame sits on the guides located on the side rails "3". Position the slat frame so that the holes in the frame align with those in the side rails "3".
Need help?
Do you have a question about the KINGSBURY BED and is the answer not in the manual?
Questions and answers