Technical Problems - Kenwood KDW60X18 Installation Instructions Manual

technical problems

problem
The dishwasher does not start.
Water remains inside
the machine.
Machine stops during
washing.
Knocking noise in the
wash cabinet.
Partial food wastes
remain on the dishes.
34
Kenwood Freestanding Dishwasher KDW60T18/X18 Manual.indd 34
possible causes
Your Dishwasher is not plugged
in.
Your Dishwasher is not
switched on.
Fuse blown.
Water inlet tap is closed.
Your Dishwasher door is open.
Water inlet hose and machine
filters are clogged.
Water drain hose is clogged or
twisted.
The filters are clogged.
The programme is not finished
yet.
Power failure.
Water inlet failure.
A spray arms is knocking
against an item in a basket.
Dishes incorrectly placed.
Dishes placed incorrectly,
sprayed water not reaching
affected dishes.
Dishes leaning each another.
Not enough detergent used.
Wrong wash programme
selected.
Spray arms clogged with food
waste.
Filters or water drain pump
clogged or filter misplaced.
remedy
Plug your Dishwasher in.
Switch your Dishwasher on by
pressing the On/Off button.
Check your indoor fuses.
Turn on the water inlet tap.
Close the Dishwasher door.
Check the water inlet hose and
machine filters and make sure
they are not clogged.
Check the drain hose, then either
clean or untwist it.
Clean the filters.
Wait until the programme is
finished.
Check mains power.
Check water tap.
Interrupt the programme and
rearrange the items which are
obstructing the spray arm.
See the section "Loading the
dishwasher".
Do not overload baskets.
Place dishes as instructed in
the section on loading your
dishwasher.
Use the correct amount of
detergent, as instructed in the
programme table.
Use the information in the
programme table to select the
most appropriate programme.
Clean the holes in the spray arms
with thin objects.
Check the drain hose and filters
are correctly fitted.
07/06/2018 15:59