Section 14: Adjusting Needle Height - Baby Lock Regalia BLRG20 Service Manual

Section 14: Adjusting the Needle Height
Hold Needle Bar
Page 36
ools required: (#3 Flat screwdriver)
T
1mm
Check: The needle height must be set so that when
viewed from behind as shown, and with the hook
point flush with the right side of the needle, the
bottom of the hook point should be 1.0 mm above
the top of the needle eye .
If a correction is necessary:
• Remove the nose cover screw.
• Lower the needle bar to its lowest position to
• Insert a screwdriver through the access hole
• Hold the needle bar with your other hand to
• While holding the needle bar with one hand,
 NOTE: This adjustment must be completed
with the front frame cover on. Important
 NOTE: Shown with cover off for illustration
purposes only!
 IMPORTANT: Needle bar height must be set
first with a gauge before the hook is installed
or visually checked with the hook installed and
timed correctly first. The most common check
is the visual check because the hook does not
have to be removed. Needle bar height cannot
be checked visually unless timing has first
been set correctly .
access the needle bar driver screw.
provide resistance against the adjustment, so the
needle bar will not fall down, out of the driver.
loosen the screw slightly so that the needle bar can
be wiggled up or down to the correct position.
Regalia Service Manual