Section 2: Removal Of - Baby Lock Regalia BLRG20 Service Manual

Section 2: Removal of the Front Cover
U CAUTION: Make sure the machine is unplugged from the wall before removing the front cover or
whenever working on the machine.
Tools Required: 2 mm, 3 mm, 4 mm, 5 mm handle Allen, 4 mm L Allen, #3 flat screwdriver.
BabyLock.com
1. Remove the small hex screw on the back power
inlet module closest to the three power prongs
with a 2 mm hex tool.
2. Remove the nose cover screw with a 3 mm hex
tool . Remove the nose cover .
3 Remove the needle plate screws with a #3 flat
screwdriver. Remove the needle plate.
4. Loosen the levelling screw 1 full turn with a 5 mm
handle hex tool This will take any bind off the two
large lower screws in the next step.
Page 11