Starting Procedure - Hyundai HYC6220 User Manual

6. STARTING PROCEDURE

NOTE
This machine is shipped without oil, therefore you MUST fill the engine with oil
before starting the engine. Failure to do so will result in engine damage which will not
be covered by warranty.
Fill with a 40:1 ratio of semi-synthetic 2 stroke oil and fresh unleaded petrol.
See section 5. 5.0 for further information.
6.0 Before starting the engine you must check the following;
6.1 Check the work area, object/s to be cut and proposed cutting direction. You MUST
remove and obstacles before starting work.
6.2 NEVER start cutting until you have removed a clear work area, secure footing and a
planned retreat path from any falling pieces of cut wood.
6.3 ALWAYS use extreme caution and keep bystanders and animals clear of the work
area which must include the area where cut branches and trees will fall.
6.4 Inspect the machine for and worn, loose or damaged parts. NEVER operate a
machine that is damaged, improperly adjusted, or is not complete and securely
assembled. You MUST make sure that the saw chain stops moving when the throttle
control trigger is released. If the chain does not come to a stop you must adjust the
idle speed of the engine.
6.5 Always hold the machine firmly with both hands when the engine is running.
6.6 Keep all parts of your body away from the machine when the engine is running.
6.7 Before starting the engine, make sure the saw chain is not in contact with anything.
6.10 Fill the chainsaw with the correct fuel/oil mix (40:1) and fill the chain oil tank and
tighten the caps securely.
Saw Chain Oil Tank
16
Fuel/Oil Tank