Table of Contents
Advertisement
assembly continued...
3.9
Fit the chain cover back to the power unit making sure the chain tensioner stud
passes through the lower adjustment hole on the guide bar and tighten the nuts
finger tight (7).
3.10
While holding the tip of the bar, adjust the chain tension by turning the tensioner
screw until the tie straps on the chain just touch the bottom side of the guide bar
rail (8 & 9).
7
3.11
Tighten the chain cover nuts securely with the bar tip held up (12~15Nm).
Then check the chain for smooth rotation and proper tension by moving it by hand.
If necessary, re-adjust with the chain cover loose.
CAUTION
The saw chain is very sharp and MUST be handled using thick protective gloves.
NOTE
A new chain will stretch in length when first used. Check and re-adjust the tension
frequently as a loose chain can easily derail or cause rapid wear of the saw chain
and the guide bar.
8
13
9
Hide quick links:
Advertisement
Table of Contents
