Configuring A Rendezvous Point - Cisco Catalyst 2960-XR Configuration Manuals

Configuring PIM
Command or Action
Step 6
show running-config
Example:
Switch# show running-config
Step 7 copy running-config startup-config
Example:
Switch# copy running-config
startup-config
Related Topics
PIM Stub Routing, on page 39
Example: Enabling PIM Stub Routing, on page 71
Example: Verifying PIM Stub Routing, on page 71

Configuring a Rendezvous Point

You must have a rendezvous point (RP), if the interface is in sparse-dense mode and if you want to handle
the group as a sparse group. You can use several methods, as described in these sections:
• Manual assignment
• As a standalone, Cisco-proprietary protocol separate from PIMv1
• Using a standards track protocol in the Internet Engineering Task Force (IETF)
OL-29426-01
For information about this procedure, see
For information about these procedures, see the following sections:
◦ Setting Up Auto-RP in a New Internetwork, on page 50
◦ Adding Auto-RP to an Existing Sparse-Mode Cloud, on page 52
◦ Preventing Join Messages to False RPs, on page 55
◦ Filtering Incoming RP Announcement Messages, on page 55
For information about this procedure, see
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
Configuring a Rendezvous Point
Purpose
(Optional) Verifies your entries.
(Optional) Saves your entries in the configuration file.
Manually Assigning an RP to Multicast Groups, on page 48
Configuring PIMv2 BSR, on page 57
47