Table of Contents
Advertisement
COMPACT 5000 Analog 8-channel Current/Voltage Input Module
Use a Cable Tie
After you connect the required wires to the RTB, you can use a cable
tie to bundle the wires. There is a lower hook at the bottom of the
module that you use to secure the tied bundle to the module.
1. Make sure that you have a cable tie long enough to contain the
wires that are connected to the module.
The maximum width of the cable tie is 4.5 mm (0.18 in).
2. Gather the wires at the bottom of the module.
3. Thread the cable tie through the lower hook at the bottom of
the RTB..
4. Wrap the cable tie around the wires and secure it.
12
Rockwell Automation Publication 5069-IN010B-EN-P - November 2017
Power the System
After you install all Compact 5000 I/O modules, you can turn on
MOD power and, if used, SA power to the system.
For more information on MOD power and SA power, see
Power Considerations on page
6.
Remove the Module
ATTENTION: Do not remove or replace the module while power is
applied. Interruption of the backplane can result in unintentional
operation or machine motion.
1. Confirm that MOD power and all sources of SA power are
turned off.
IMPORTANT
Before you remove power from the MOD power RTB
and, if used, SA power RTB, consider the effect on
your system.
When you remove MOD power and SA power from a
controller or adapter, you shut down power to all
Compact 5000 I/O modules in the system. That is, all
system-side and field-side power is removed.
We strongly recommend that you take the
appropriate actions to help prevent unintended
consequences that can result from a system power
shutdown before you remove MOD power and
SA power.
2. If necessary, remove the end cap from the right side of the
module.
3. If desired, disconnect wires from the RTB as described on
page
9.
4. Press the DIN rail latch down until it clicks and let go of the
latch.
5. Pull the module off the DIN rail.
ADA PTER
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
6. To replace the module, follow the steps that are described
beginning at
Install the Module on page
System
ADA PTER
AEN TR
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
7.
- Quick Links:
- Wiring Diagram
Hide quick links:
Advertisement
Table of Contents
