Installation/Removal Of Collection Bags - Cub Cadet Pro2B+ 21120902 Operator's Manual

2-16 Installation/Removal Of
Collection Bags
IMPORTANT!
To prevent bag wear, install (1) black rubber end cap
P#(F0010), as shown in Figure 2-16a, on each bag ring
after rotating bag 360.
Figure 2-16a
To complete the bag installation, place the seam
openings of the bag and the bag ring openings together.
Place the rubber bag ring connector on both ends of the
bag ring and turn the bag one half turn (180 ) so the
rubber end cap is located opposite to the opening in the
bag (Figure 2-16b). Do this for each bag.
Figure 2-16b
Bag Ring Rubber End
Install the completed assemblies onto the support frame
and close the plastic top. Fasten the draw-latches to
hold the plastic top closed (Figure 2-16c).
14
Bag Ring
Black Rubber
Connector
Cap Opposite
of Bag Opening
Bag Opening
Bag
Figure 16-c
Figure 2-19c
Completed Bag
Installed
To empty the bag, first unlatch and lift top, next remove
the bag and bag ring by sliding rearward, then grasp the
handle on the bottom of the bag, and last turn it upside
down to empty the collected debris (Figure 2-16d).
Repeat for the other bag. Reinstall both bags, line with
plastic bags if desired, close the plastic top and reattach
the draw latches.
Figure 2-16d
Plastic lawn and leaf bags, 33 gallon size, may be used
inside the cloth bags. Be sure to leave enough plastic
bag hanging over the frame so the plastic bags can be
twist tied before emptying (Figure 2-16e).
Figure 2-16e
Plastic Bag
Plastic Top
Fasten Draw-
Latch Here &
Opposite Side
For Proper Unit
Transportation
Grasp Bag
Here
Cloth Bag