Length Of Hose Adjustment; Upper Hose Installation; Lower Hose To Blower Cone Installation; Lower Hose To Boot Installation - Cub Cadet Pro2B+ 21120902 Operator's Manual

2-12 Length Of Hose Adjustment

The hoses in steps 2-13 and 2-14 must be cut to fit your
machine. Follow steps 2-13 and 2-14. do not cut the
hoses until you have tried to fit them on your machine.
Remember that the hoses have to be long enough to
adjust for the blower assembly's movement as well as
allow for enough clamping surface between the inlet,
blower assembly, and the deck boot.

2-13 Upper Hose Installation

Fasten the inlet to the plastic top by sliding the inlet from
the inside of the top to the outside and lock into place.
Slide a hose clamp P#(J0060) onto one end of the 6"
upper hose (Figure 2-13). Next, slide opposite
end of the 6" hose onto the inlet. Make sure that the
hose is in position to be secured by the Snap Fastener
P#(K0508). Proceed to slide the opposite end of the 6"
hose onto the outlet of the blower assembly. Make sure
both ends of the hose are clearly attached to the inlet
and the blower assembly inlet. Tighten the hose clamp.
Figure 2-13
Inlet
Upper
Hose
Blower
Outlet
Snap
Fastener
Hose
Clamps
Blower
Lower
Cone
Hose
2-14 Lower Hose To Blower Cone
Installation
Slide a clamp P#(J0080) over both ends of the lower
hose. Then proceed to slide the lower hose onto the
blower cone. Tighten the hose clamp. The
assembly should look like Figure 2-13.

2-15 Lower Hose To Boot Installation

Take the unattached end of the lower hose and slide it
over the circular end of the boot. Use the lower hose
clamp to secure the hose to the boot (Figure 2-13). Tip:
Before securing clamp rotate hose counter-clockwise
(away from yourself) approximately 1" to aid in retaining
boot to mower deck.
Hose
Clamps
Boot
13