Blower Cone Installation - Cub Cadet Pro2B+ 21120902 Operator's Manual

2-10 Blower Cone Installation

Thread (1) 5/16"-18 jam nut P#(K0120) onto each end of (2) 5/16"-18 x 2-1/2" HHCS P#(K0125) as
shown in Figure 2-10a.
Now partially thread (1) bolt into each of the two threaded bosses located on the blower housing. Place
8" Blower Cone P#(E6009) so the two tabs line up with the bolts and tighten completely as shown in
Figure 2-10b.
Once the (2) bolts are tight, tighten the jam nuts against the threaded boss as shown in Figure 2-10c.
Refer to Figure 2-10d for proper blower cone installation reference.
Figure 2-10d
Thread (1) Jam Nut
Onto Each 5/16"-18 Bolt
Figure 2-10b
Threaded
Boss
Figure 2-10c
(2nd) Tighten
Jam Nut
Blower
Cone
Figure 2-10a
Blower
Cone Tab
(1st) Tighten
Bolt
11