Installation/Removal Of Collection Bags - Cub Cadet 59A30045150 Operator's Manual

2-18 Installation/Removal Of
Collection Bags
IMPORTANT!
To prevent bag wear, install (1) Black Rubber End Cap
P#(F0010), as shown in Figure 2-18a, on each Bag Ring
after rotating bag 360.
Figure 2-18a
To complete the bag installation, place the seam
openings of the bag and the bag ring openings together.
Place the rubber bag ring connector on both ends of the
bag ring and turn the bag one half turn (180 ) so the
rubber end cap is located opposite to the opening in the
bag (Figure 2-18b). Do this for each bag.
Figure 2-18b
Bag Ring Rubber
End Cap Opposite
of Bag Opening
Install the completed assemblies onto the support frame
and close the plastic top. Fasten the draw-latches to
hold the plastic top closed (Figure 2-18c).
Bag Ring
Black Rubber
Connector
Bag Opening
Bag
Figure 2-18c
Completed Bag
Installed
To empty the bag, first unlatch and lift top, next remove
the bag and bag ring by sliding rearward, then grasp the
loop on the bottom of the bag, and last turn it upside
down to empty the collected debris (Figure 2-18d).
Repeat for the other bag. Reinstall both bags, line with
plastic bags if desired, close the plastic top and reattach
the draw latches.
Figure 2-18d
Plastic lawn and leaf bags, 33 gallon size, may be used
inside the cloth bags. Be sure to leave enough plastic
bag hanging over the frame so the plastic bags can be
twist tied before emptying (Figure 2-18e).
Figure 2-18e
Plastic Bag
14
Plastic Top
Fasten Draw
-Latch Here
For Proper Unit
Transportation
Grasp Bag
Here
Cloth Bag