Length Of Hose Adjustment; Upper Hose Installation; Lower Hose To Blower Cone Installation; Lower Hose To Boot Installation - Cub Cadet 59A30045150 Operator's Manual

2-14 Length Of Hose Adjustment

The hoses in steps 2-15 and 2-16 must be cut to fit your
machine. Follow steps 2-15 and 2-16. do not cut the
hoses until you have tried to fit them on your machine.
Remember that the hoses have to be long enough to
adjust for the blower assembly's movement as well as
allow for enough clamping surface between the inlet,
blower assembly, and the deck boot.
Note: The upper hose should be no shorter than 32".

2-15 Upper Hose Installation

Fasten the inlet to the plastic top by sliding the inlet from
the inside of the top to the outside and lock into place.
Slide a pre-assembled hose clamp P#(J0060) onto both
ends of the 6" upper hose (Figure 2-15). Then slide one
end of the 6" hose onto the inlet. Make sure there is
about a two-inch overlap between the hose end and the
container inlet. Proceed to slide the opposite end of the
6" hose onto the outlet of the blower assembly. Make
sure both ends of the hose are clearly attached to the
inlet and the blower assembly inlet. Tighten the hose
clamps.
Figure 2-15
Inlet
Upper
Hose
Blower
Outlet
Hose
Clamps
Blower
Lower
Cone
Hose
2-16 Lower Hose To Blower Cone
Installation
Slide a pre-assembled hose clamp P#(J0080) over both
ends of the lower hose. Then proceed to slide the lower
hose onto the blower cone. Tighten the hose clamp. The
assembly should look like Figure 2-16.

2-17 Lower Hose To Boot Installation

Take the unattached end of the lower hose and slide it
over the circular end of the boot. Use the lower hose
clamp to secure the hose to the boot (Figure 2-15). Tip:
Before securing clamp rotate hose counter-clockwise
(away from yourself) approximately 1" to aid in retaining
boot to mower deck.
Hose
Clamps
13
Boot