Troubleshooting - Icom IC-GM1600E Instruction Manual

PROBLEM
The transceiver does not The battery is exhausted.
turn ON.
Bad connection to the battery pack.
N o s o u n d f r o m t h e Squelch level is too deep.
speaker.
Volume level is too low.
Speaker has been exposed to water.
Water has entered to the [MIC/SP]
connector.
Transmitting is impossible, The battery is exhausted.
or high power can not be
selected.
The output power is set to low.
The displayed channel Lock function is activated.
cannot be changed.
No beeps. Beep tones are turned OFF.
Self check error. The temperature is outside of –35°C to
(Temperature) +80°C (approximate).
Self check error. The connected battery pack's voltage
is more than 11 V.
(Battery voltage)
Transmitting continuously Ambient noise is too loud.
while not speaking when
using VOX function.
POSSIBLE CAUSE

TROUBLESHOOTING

SOLUTION
• Change the new battery pack (Survival).
• Recharge the battery pack (On-board).
Check the connection to the transceiver. p. 3
Set squelch to the threshold point.
Rotate [VOL] to set a suitable level.
Drain water from the speaker.
Dry the [MIC/SP] connector.
• Change the new battery pack (Survival).
• Recharge the battery pack (On-board).
Push [Hi/Lo• ] to select high power. p.8
Push [Hi/Lo• ] for 1 second to can-
cel the function.
Set the beep tones to ON (Fix Beep/
User Beep) on the SET mode.
Leave the transceiver at room temper-
ature for a while. Turn the power ON to
check if the internal temperature has
returned to normal.
Verify the battery voltage is correct.
• Remove the headset cable.
• Set the VOX gain to dulling.
9
REF�
p.15
pp. 16~19
p. 9
p. 8
–
–
8
p.15
pp. 16~19
9
p. 10
p. 12
–
–
p. 14
21 21