Table of Contents
Advertisement
SATRON VC Optical Consistency Transmitter
SAMPLES:
SAMPLES:
The history of the sample (10). Laboratory values input.
SAMPLE 01:
Upload a sample 1.
SAMPLE 09:
Upload a sample 9.
SAMPLE H
O:
2
The water value
CALIBRATE:
Calibration with sample (1/2-point).
SAMPLE 01:
SAMPLE 09:
SAMPLE H
O:
2
The calibration list of suitable samples (samples
recorded fed laboratory value).
CALIBRATION HISTORY:
Transmitter calibration history.
The date / time stamped list of calibrations.
3.4 DIAGNOSTICS
(This submenu allows you to examine the transmitter's
internal errors and faults, to set the transmitter to give out
a fi xed current, and to calibrate the transmitter.)
STATUS:
Here you can display and reset accumulated errors one
at a time. The text OK will be displayed if there are no
errors. Possible error messages (alarm means a serious
fault/error that also puts the current signal in fault status
and makes the display blink).
Table 1, the content of error word 1, page 18.
LOOPTEST:
The transmitter can be set to give out a fi xed current sig-
nal for testing the mA output. The fi rst ENTER will switch
the transmitter off from normal mode (AUTO OFF), the
second ENTER will set it for 4 mA output, and the third
ENTER for 20 mA output. The next ENTER after that
will give default value 12 mA, which can be changed as
desired with the UP/DOWN keys. The last ENTER will
switch the transmitter back to normal mode (AUTO ON).
The purpose of this test is to test the accuracy of the
transmitter's current output with a reference meter.
TR
TR
TRB TRIM:
The transmitter calibration factory units (FU).
Th
Th
TRB ZERO
Calibration of measurement by two points
LRW.TRIM
UPR.TRIM
REMOVE
SE
SE
SENSOR TEMPERATURE TRIM:
Se
Se
Sensor Temperature Trim. Here you are able to calibrate
th
th
the temperature probe which is placed in the head of the
an
analyzer. (Maximum by 10 degrees.)
an
LOOP CALIBRATION:
LO
LO
He
Here you can calibrate the current signal given by the
He
transmitter. The fi rst ENTER will switch the transmitter
tr
tr
of
of
off from normal mode (AUTO OFF). The next ENTER will
ma
ma
make the transmitter give out a signal which it assumes
to
to
to be 4 mA. Use the UP/DOWN keys to change this value
in
in accordance with the reading on the reference meter.
in
Then press ENTER for 20 mA output, which you must
Th
Th
al
al
also set in accordance with the reference meter. Press
EN
EN
ENTER to accept the new reading.
No
No
Note: Use a suffi ciently accurate reference meter.
I/O
I/O
I/O TEST:
The digital inputs and outputs, as well as the power out-
Th
Th
pu
pu
put of the second test. Income status is displayed on the
sc
sc
screen and change the status of the outputs
HARDWARE:
HA
HA
VOLTAGES
I/O COMM
LO
LO
LOG:
ADD TXT
DATA LOG
CYCLIC
DIC I/O
OFF
13
13
3
3 3
BCs220AV
15.10.2014
measurement of zero
calibration of the lower point
calibration of the upper point
delete of calibration
the voltage diagnostics
device I / O communication diag-
nostic diagnostics (only housing
type L)
text (8 characters) increase in the
event log
data log mode:
continuous (default)
selected with digital inputs
off
Revision 2
Hide quick links:
Advertisement
Table of Contents
