A.O. Smith LILY User Manual page 7

Do not use this water purifier under high
water pressure conditions!
Operating under high pressure conditions
may cause the water purifier pipes to rupture,
resulting in leakage, the machine working
improperly, or even serious property damage.
Recommended inlet pressure is
0.1-0.35 MPa (1 Bar to 3,5 Bars)
In places where inlet water pressure is
more than 0.35 MPa (3,5 Bars), it is
recommended to use a pressure reducer
before the unit.
Use only power supply unit (the supply cord
and the plug) that was provided with the unit!
Using the non-original power supply unit may
affect the performance of the unit negatively
and using unqualified parts may damage to
the unit.
If the supply cord is damaged, supply an
original cord from your A.O.Smith Sales Agent
or A.O.Smith Authorized Service!
Using the non-original supply cord unit may
affect the performance of the unit negatively
and using unqualified parts may damage to
the unit.
Do not damage the power cord
or the outlet!
Doing so may lead to electric shock, short
circuiting or fire.
Do not use a power source exceeding
the equipment's specified value. Use only
230V AC power!
The electrical current supplied to your
equipment by the outlet must not be greater
than the specified value; otherwise it may
230 V
lead to the overheating of your equipment
or fire.
The equipment must be disconnected from
the power supply during installation
and repairs!
Otherwise it may lead to electric shock.
Do not touch the power plug with wet hands!
It may lead to electric shock.
Unit should be installed and connected to
the water mains by new hose-set that was
included in the product package. Old
hose-sets should not be reused with the unit.
Otherwise water leakages may occur or
the unit's performance may be affected
negatively.
Do not use the water purifier when the sewer
is blocked up!
If the purifier is used while the sewer is
blocked, it may cause waste water to back
up into the purifier and pollute the water
and parts inside.
ENG 5