Adjusting Sections; Fixing The Sail Feeder - Facnor LS PLUS Installation Manual

4.10- ADJUSTING SECTIONS

Tighten the backstay to put some tension onto the forestay.
Leave the feeder piece resting on the drum.
Raise all of the sections together until they touch the top terminal of the forestay. Insert a
screw into one of the lower holes of the last section.
BEWARE: DO NOT OVERTIGHTEN IT
sections slowly descend until a hole coincides with the first of the threads on the telescopic
section.
top
40 mm-139mm

4.11- FIXING THE SAIL FEEDER

LS / RX / RS RANGE
4.11.1- For the «LS», «RX» and «RS» range, aligns holes in the telescopic section with holes
in the feeder. Then, screw down the feeder with the screw provided.
4.11.2- For the «LX» range, first, put the stainless steel feeder into its support. Then, align
holes of the telescopic section and the feeder. Finally, screw down the feeder with screw
provided.
F a c n o r - I n s t a l l a t i o n m a n u a l r e v 2 0 1 2 – L S + / L X + / R X + r e e f i n g a n d f u r l i n g s y s t e m s
IMPORTANT :
Make sure that sections have descended at least
50mm before the screw slots into place. Otherwise,
proceed to the next hole, 100mm below.
Leave a margin of 40-139 mm between the halyard
deflector and the bottom of the forestay top terminal.
The ideal position of the feeder is between 600 and
800 mm above the drum shackle.
top
4.11.1
. Press the screw with your thumb and let the
LX RANGE
top
2
3
4.11.2
English
1
27