4- Assembly Stages; Assembly Of The Halyard Deflector; Assembly Of The Top Cap And The Top Section - Facnor LS PLUS Installation Manual

4- ASSEMBLY STAGES :

4.1 – ASSEMBLY OF THE HALYARD DEFLECTOR*
top
F

4.2- ASSEMBLY OF THE TOP CAP AND THE TOP SECTION

top
4.2.1
Slip the stainless
steel plate and then
the top cap around
the forestay.
Position the plate
by slipping it into
the notches on the
cap, designed for
this purpose.
top
The pins are simply used to fix the cap. Therefore, do not hit too hard or you
may damage the cap.
F a c n o r - I n s t a l l a t i o n m a n u a l r e v 2 0 1 2 – L S + / L X + / R X + r e e f i n g a n d f u r l i n g s y s t e m s
memale part
Slip the disk around the forestay, screw pointing up.
Assemble the two half bushings above the deflector disk
and around the forestay, the "female" part pointing up.
Fit the bushing into the halyard deflector. Then tighten the
screw (fig. F), which will fix the bushing in place.
*N LS/LX330 models, the halyard deflector wheel has been
replaced by a block diverting the halyard and this is to be riveted
onto the mast (see page p29 for further explanations).
top
male
part
1/4
4.2.2
Around the forestay ,
assemble a
bushing, then
second one,
"male" part pointing
up. Fit the bushing
together, and
the bottom bushing a
quarter trun.
Those two
bushings are
now joined.
male
top
part
1/4
top
1/4
4.2.3
Put the bushing set
first into the cap, give
a another quarter
the turn to
bushings.
Doing
give
ensures that the
bushings
fixed in place in
the top.
top
1/4
top
4.2.4
Take the top section
and fix it snugly into
the top
the assembly
possible,
bushings a half turn in
this
the cap.
Place the two pins into
are
the holes in the top
cap and the stainless
steel plate. The, tap
them into the section
groove with a mallet.
top
English
cap. If
is not
give the
23