Table of Contents
Advertisement
The power cord supplied with Series 2230G power supplies contains
a separate protective earth (safety ground) wire for use with
grounded outlets. When proper connections are made, the
instrument chassis is connected to power-line ground through the
ground wire in the power cord. In addition, there is a ground terminal
for each channel on the rear panel. When a channel is enabled, its
ground terminal should be connected to a protective earth. In the
event of a failure, not using a properly grounded protective earth and
grounded outlet may result in personal injury or death due to electric
shock.
Do not replace detachable mains supply cords with inadequately
rated cords. Failure to use properly rated cords may result in
personal injury or death due to electric shock.
When using the Model 2230G-30-6 or 2230G-60-3 in a country that is a
member of the European Union, you need to use the 2230G-HRM
Harmonic Reduction Module in line with the mains power cord to comply
with European Union regulations. If you use the 2230G-HRM, the
functions of the instrument are not affected.
To power on the 2230G-30-3:
1.
Make sure the front-panel power switch is in the off (0) position.
2.
Properly set the 110 V/220 V selector switch on the bottom of the
instrument.
3.
Connect the female end of the supplied power cord to the AC
receptacle on the rear panel, as shown in the following figure.
Operating the instrument with an incorrect voltage may cause
damage to the instrument, possibly voiding the warranty.
4.
Connect the plug of the power cord to a grounded AC outlet.
Advertisement
Table of Contents
