Table of Contents
Advertisement
Section 1: Assembly & Set-up
Refer to Figure 1-28:
13. Remove parking jack (#3) from left-hand wing deck
and attach to the cutter hitch. Secure parking jack in
place with ball detent pin (#8).
14. Unhook hydraulic hoses (#6 & #7) from tractor duplex
outlet. Insert couplers through spring hose loop to
keep couplers out of the dirt.
15. Unhook wire harness (#11) from tractor outlet. Coil
wire harness and store over spring hose loop with
connector hanging down to keep moisture out.
16. Unhook hitch safety chain (#4) from tractor.
17. Pull back on locking collar (#10) and pull
driveline (#5) from tractor power take-off shaft.
18. Collapse driveline (#5) by pushing tractor end of
driveline toward the splitter gearbox.
19. Adjust park jack (#3) to raise cutter up until all load is
removed from tractor drawbar.
20. Remove connecting hitch pin or bolt as follows:
a. For Standard Clevis Hitch, See Figure 1-28:
Remove hairpin cotter (#2) and hitch pin (#1).
a. For LP Performance Hitch, See Detail B in
Figure 1-29:
Remove hairpin cotter (#2) and hitch pin (#1).
b. For Bar-Tite Hitch, See Figure 1-30: Remove
locknut (#2) and bolt (#1).
21. Restart tractor and drive tractor slowly forward
several feet.
22. Shut tractor down properly before dismounting.
23. Lower park jack (#3) until cutter is resting on its front
skid shoes.
24. Replace connecting pin/bolt (#1) as follows:
a. For Standard Clevis Hitch, See Figure 1-28:
If unhooking standard clevis, replace connecting
pin (#1) in clevis (#9). Secure hitch pin with
hairpin cotter (#2).
b. For LP Performance Hitch, See Detail A in
Figure 1-29:
Rotate clevis (#9) horizontal and flip hitch holder
(#12) up so that its holes are on top as shown.
Insert customer-supplied hitch pin (#1) through
holes in hitch holder (#12). Secure with hairpin
cotter (#2).
c. For Bar-Tite Hitch, See Figure 1-30:
If unhooking bar-tite hitch, remove hitch (#11) from
tractor drawbar and reattach it to the hitch (#9)
with removed bolt (#1) and locknut (#2) Screw
locknut on 4 or 5 full turns. Do not torque nut tight.
9/25/18
Table of Contents
33861
Tractor Unhooking from Standard Clevis Hitch
37998
Unhook Tractor From Bar-Tite Hitch
Unhook Tractor From Bar-Tite Hitch
Figure 1-28
Figure 1-29
Figure 1-30
RC3620 & RCM3620 Rotary Cuters 330-841M
33870
27
Advertisement
Table of Contents
