One Source Multiple Displays; Configure Network Switch; Enable Igmp Snooping - Binary B-900-MOIP-4K-CTRL Installation & Setup Manual

One Source Multiple Displays

Control System
Cablebox Cablebox
CONFIGURATION

1. Configure Network Switch

(Steps below use an Araknis 210 PoE or 310 PoE Series switch as an example)
1. Factory default the
switches). Press and hold the reset button for 10—15 seconds until the Status LED flashes
once. This will reboot the switch and reset to factory settings.
2. Connect the dedicated MoIP switch directly to your
switch is the main network switch into which all other switches and network devices are
connected. The Main LAN switch is the only switch connected to the router. A dedicated
MoIP switch is preferred but not required. (See 'Network Guide' for more information.)
3. Access the local UI of the
Note:
Default login in credentials for an Araknis switch are araknis / araknis. The Default IP
address is 192.168.20.254.

2. Enable IGMP Snooping

Choose ADVANCED > MULTICAST > IGMP
1. Status: Enabled
2. Version: V2
3. Report Suppression:
4. Unregistered IPMC Forward Action:
5. IGMP Snooping Status:
6. Fast Leave: Enabled
7. Querier State:
8. Querier Version:
9. Router Settings > Router Ports Auto-Learned:
Click Apply to save these settings
Cat5e Cat5e
Stereo Input (1-5) Stereo Input
801e Amp 801e Amp
MoIP switch
MoIP Switch.
Enabled
Enabled
Enabled
V2
MoIP Switch
Cat5e Cat5e
Cat5e Cat5e
MoIP RX 1 MoIP RX 1
Cat5e Cat5e
MoIP RX 2 MoIP RX 2
Cat5e Cat5e
MoIP RX 3 MoIP RX 3
Cat5e Cat5e
MoIP RX 4 MoIP RX 4
Network
+5VDC
MoIP Controller MoIP Controller
to be used for all MoIP components (not necessary for new
Main LAN
SNOOPING, then check options as follows:
Flood
Enabled
9
HDMI HDMI
IR IR
Living Room - Sony 4K Display 1
Serial Serial
HDMI HDMI
Guest Bedroom - Sony 4K HDR Display 2
Serial Serial
HDMI HDMI
Outdoor TV - SunBriteTV 4K Display 3
IR IR
HDMI HDMI
Master Bedroom - LG 1080p Display 4
switch. The Main LAN
Model A
Model A