Set Up Control System - Binary B-900-MOIP-4K-CTRL Installation & Setup Manual

Set up Control System

Integrating MoIP with your chosen control system is very similar to the steps to integrate
a matrix switcher. The Binary team has developed custom drivers and worked with control
system manufacturers to certify.
The following control system drivers, models and documentation are available:
Please refer to individual driver support documents for specific features and capabilities.
For greater control and integration, the full application programming interface (API)
for the MoIP Controller is available for download on the support tab.
• Basic switching control: An IP control system is required to control the system transmitter-
receiver switching. No serial or IR system switching control is supported.
• RS-232/Serial Generation: RS-232/Serial commands are generated at each transmitter
and receiver. Make connections from the receiver or transmitter end points directly to the
devices to be controlled. RS-232 commands sent over IP and are generated at each end
point. To integrate, in the control system driver, link each transmitter and receiver's serial
port to the devices to be controlled. Refer to the Serial & IR Control document for more
information
• Infrared (IR) Routing: Infrared control signals are passed bi-directionally over the static
routes establish on the
(UI). These routes create virtual wires simplifying the integration process. To integrate these
static 2-way IR routes with the control system, link control system IR outputs directly to
the device to be controlled based on the IR Link settings. Refer to the Serial & IR Control
document for more information.
• CEC Stand-by & Power On: CEC can be enabled via the control system driver and
supports Stand-by and Power On commands. Details of this are provided in specific driver
documentation. CEC compatibility varies between display manufacturers and should be
tested for each install to ensure maximum reliability. Other control options may be required
for your specific application.
• Audio De-embedding: The L/R stereo audio outputs on the transmitter and receiver, when
stereo content is present, extracts this audio for convenient input into multi-room audio
distribution systems. No control system integration is necessary.
IR Links Settings page on the MoIP controller local user interface
18
MoIP API