Omega CN616TC1 User Manual page 17

6.4.4 Function [34]
The ID code for the RS-232 is the identifying number for each unit
connected through an RS-232 line to a computer. If two or more
units are connected to a computer every unit must be set to have a
different RS-232 ID code for proper operation. In function [34] the
function display will show 34, the zone display will be blank, and the
upper display will display the 1 digit RS-232 ID code. To increment
the flashing digit use the button
To save the settings and return to function [71] use the button
6.4.5 Function [35]
The zone display time function sets the time period that each tempera-
ture will display in the temperature window. The zone display is
settable to 1-40 seconds.
In function [35] the function display will show 35, the zone display will
be blank, and the upper display will show the two digit zone display
time.
To increment the flashing digit use the button
To advance to the next digit use the button
To save the settings and exit to function [71] use the button
6.5 Function Group [72] Setpoints and Alarms
Function [72] controls functions [36] to [38]
On entering function [72] the function display shows 72. The upper
display reads 36. To select functions [36] to [38] increment the flashing
digit with the button When the desired function is displayed enter
it with the button This will display set function in function
display.
If the process times out the display will return "RUN" Mode.
To return to function [70] press two buttons
for a few seconds.
6.5.1 Function [36]
The setpoint function allows setting the control point of the temperature
controller for each zone. This setpoint is for STANDARD CONTROL
only. Ramp and Soak setpoints are set in function 75, or computer.
29
ID for RS232
zone display time
and together
setpoint
In function [36] the function display will show 36, the zone display will
show 1, and the upper display will show the current setpoint.
To increment the flashing digit of the setpoint use the button
To advance to the next digit use the button
To save the settings and go to the next zone use the button
To exit to function [72] use the buttons
a few seconds.
6.5.2 Function [37]
The high alarm function sets the high temperature safety point for each
zone above which each zone will go into alarm mode.
In function [37] the function display will show 37, the zone display will
show 1, and the upper display will show the two digit current alarm
setting.
To increment the flashing digit of the setpoint use the button
To advance to the next digit use the button
To save the setting and go to the next zone use the button
To exit to function [72] use the buttons
few seconds.
6.5.3 Function [38]
The low alarm function sets the low temperature safety point for each
zone below which each zone will go into alarm mode. To prevent
alarming on low temperature during start-up the low alarm is disabled
until the zone exceed it's setpoint for a set period of time.
In function [38] the function display will show 38, the zone display will
show 1, and the upper display will show the two digit current alarm.
To increment the flashing digit use the button
To advance to the next digit use the button
To save the setting and go to the next zone use the button
To exit to function [72] use the buttons
few seconds.
30
and together for
high alarm (over setpoint)
and together for a
low alarm (under setpoint)
and together for a