Neuropace RNS 5000 User Programming Manual page 59

Tablet Instructions
Figure 37 Detection simulation in all ECoGs
•
To hide the simulation on the ECoG, select H
C .
LEAR
•
Detection parameters that affect sensitivity are key: adjustments that increase sensitivity tend
to increase how early and how often the pattern is detected; adjustments that decrease
sensitivity tend to decrease how early and how often the pattern is detected.
•
To adjust sensitivity, the two most common parameters to adjust are the ones with sliders
directly on the D
sliders adjust A
S
ENSITIVITY
Note: The parameter values are shown to the right of each slider. For all four parameters, lower
values result in greater sensitivity. Make adjustments and observe the effects on the simulation.
•
The M C
ORE
settings.
5. Select D
ONE
saved until you save it in the next step.
6. Save and Program: Back in the N
rename the updated detection set if desired in the S
S . Then select R
AVE
approximately 1 inch of the neurostimulator, follow the prompted steps to C
P
ROGRAMMING
®
RNS System Programming Manual
P dialog. For S
EFINE ATTERNS
(%) and D
MPLITUDE
(%) and D (seconds).
ETECT
button gives access to additional adjustment options and advanced
ONTROLS
at upper right to close the D
EUROSTIM
& P
EVIEW ROGRAM
and C sending the new settings to the neurostimulator.
ONTINUE
. To remove the pattern on the ECoG, select
IDE
A
PIKE CTIVITY
(seconds). For P
URATION
P dialog. The detection set is not
EFINE ATTERNS
S screen, select S
ETTINGS
D
AVE ETECTION
at upper right and, while holding the wand within
and R A
HYTHMIC CTIVITY
C , the sliders adjust
OWER HANGE
at upper center;
AVE
S dialog, and select
ET
ONFIRM
55
, the