Intercepting A Vor Radial - Garmin G1000 Columbia 350 Cockpit Reference Manual

Intercepting a VOR Radial

During climb-out, the autopilot continues to fly the
aircraft in Heading Select Mode. Airway V4 to Salina
VOR (SLN) should now be intercepted.
enroute flight plan waypoints correspond to VORs, flight
director Navigation Mode using either VOR or GPS as the
navigation source may be used. In this scenario, VOR
Navigation Mode is used for navigation to the first VOR
waypoint in the flight plan.
Intercepting a VOR radial:
1) Arm VOR Navigation Mode:
a) Tune the VOR frequency.
b) Press the CDI Softkey to set the navigation
source to VOR.
c) Use the CRS Knob to set the Selected Course to
255°. Note that at this point, the flight director
is still in Heading Select Mode and the autopilot
continues to fly 290°.
190-00567-01 Rev. A
Since the
Figure 6-31 Intercepting a VOR Radial
Garmin G1000 Cockpit Reference Guide for the Columbia 350/400
d) Press the NAV Key. This arms VOR Navigation
Mode and the white 'VOR' annunciation appears
to the left of the active lateral mode.
2) Once the flight director calculates the proper
capture point, the flight director transitions from
Heading Select to VOR Navigation Mode and the
'VOR' annunciation flashes green. The autopilot
begins turning to intercept the Selected Course.
3) The autopilot continues the turn until the aircraft
is established on the Selected Course.
3
2
SECTION 6 – AUTOMATIC
FLIGHT CONTROL
1
6-25