Subscribe to Our Youtube Channel
Related Manuals for ROBINHOOD Argus 90
Summary of Contents for ROBINHOOD Argus 90
- Page 1 Issue: 1 Description: ROBINHOOD RANGEHOOD Model Numbers: RHWC90X, RHWC90TB, RHWC60TG, RHWC90TG RHWC90X Brimstone 90 RHWC90TB Argus 90 RHWC90TG Adonis 90 RHWC60TG Adonis 60 Model may vary slightly from images pictured...
-
Page 2: Product Dimensions
Product Dimensions RHWC90X Brimstone 90 RHWC90TB Argus 90 RHWC90TG Adonis 90 RHWC60TG Adonis 60... -
Page 3: Pre-Installation
Pre-installation Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control and every range hood is tested and approved before it leaves the factory. Important: Please read the entire instructions before installing the rangehood. Check appliance for damage or missing parts (if damaged, do not install). -
Page 4: Ducting Options
Please note that this chart is designed as a guide. Please consult Robinhood customer services if unsure. For NZ phone (09) 415 6000 or www.robinhood.co.nz. For AUS phone 1800 648 556 or www.robinhood.com.au. -
Page 5: Installation
Installation Installation The rangehood must be installed at the correct distance above the cooktop (650mm minimum, 750mm recommended maximum). Measure up from the top of the cooktop the desired height & draw a horizontal line. From this line, measure up 350mm (RHWC90X & RHWC90TB) or 360mm (RHWC60TG & RHWC90TG) and draw a second horizontal line for the main mounting screws. -
Page 6: Fan Speed
Operating instructions Controls RHWC90TB, RHWC60TG & RHWC90TG The control panel is made up of black glass. Each function is represented by an icon, which when pressed will activate the function. Each time it is pressed a “beep” will be heard. Power Once the appliance is connected to the power source, the icons will all light up for 1 second and turn off, leaving the appliance in stand-by mode. - Page 7 Operating instructions Controls RHWC90X The control panel is made up of stainless steel with 5 buttons. Each function is represented by an icon on the button, which when pressed will light up. Each time a button is pressed a “beep” will be heard. Power Once the appliance is connected to the power source, the buttons will all light up for 1 second and turn off, leaving the appliance in stand-by mode.
-
Page 8: Filter Maintenance
Cleaning and maintenance General Maintenance Switch off the rangehood before cleaning or maintenance. To prevent surface damage never use abrasive or oil based liquid cleaners. To clean the surfaces of the appliance, use mild detergent and warm water. In areas of high humidity and coastal environments cleaning should be carried out frequently. -
Page 9: Cleaning And Maintenance
Cleaning and maintenance Fault Cause Solution The LED damaged Lights do not work, but fan LED wiring connection poor Contact Service Department works LED switch damage Motor bearings damage Motor burn out Contact Service Department Lights work, but fan does not work Motor control switch damage Plug contact outlet bad... -
Page 10: Important Safety Information
Product approvals and ratings Appliance: RHWC90X: 184W 220-240V ~50Hz LED: 2x2W Product rating RHWC90TB: 184W 220-240V ~50Hz LED: 2x2W RHWC90TG: 184W 220-240V ~50Hz LED: 2x2W RHWC60TG: 184W 220-240V ~50Hz LED: 2x2W Important safety information All electrical work must be done by a registered electrician in accordance with local and national electrical codes as applicable. - Page 11 The following conditions apply in respect of the warranty given in this certificate: 1. Monaco Corporation Limited (“Monaco”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood, Ovens, Cooktops, Dishwashers - 24 months from date of original purchase for domestic use.
- Page 12 The product was used outdoors. 2. All Robinhood Rangehoods are suitable for indoor use only and not suitable over BBQs or charcoal cookers designed for outdoor use. 3. In addition, this warranty does not extend to damage or defects which in our opinion, directly or indirectly arise from or are due to: exposing the product to acidic or corrosive materials or chemicals such as dyes, solvents, denture cleaner or acetone;...
Need help?
Do you have a question about the Argus 90 and is the answer not in the manual?
Questions and answers