Mounting The Inverter - Ningbo Ginlong Technologies Solis-20K Installation And Operation Manual

5. Installation
A sun shade is recommended to minimise direct sun exposure where ambient
temperature may exceed 40℃.
Install on a vertical surface or structure capable of bearing the weight.
Must install vertically within +/- 5. If the inverter is tilted from the vertical plane heat
dissipation can be inhibited. This may reduce system performance or reduce service
life of the inverter.
500mm
Figure 5.2 Inverter mounting clearance
A minimum of 500mm clearance is required top, bottom, left and right of the inverter
(isolator enclosures excepted) for air flow and cooling.
Visibility of the LED status indicator lights and LCD display screen should be considered.
NOTE:
The inverter must be installed out of reach of children.
.12.
500mm 500mm

5.2 Mounting the Inverter

The inverter can be mounted to the wall or metal strut of module. The mounting holes
should be consistent with the size of the bracket or the dimensions shows below.
Figure 5.3 The dimensions of the mounting bracket
The inverter should be mounted in a vertical position. The steps of mounting are as follows:
1. According to the figure 5.2, select the mounting height of the bracket and mark the
mounting holes. For brick walls, the position of the holes should be suitable for the
expansion bolts.
2.MAKE SURE the bracket is horizontal and the mounting holes A, B, and C (in
Figure 5.3) are in the correct points. Drilling the holes on the wall according
the marks.
3. Using the expansion bolts to fix the bracket to the wall.
WARNING:
The inverter must be mounted vertically on a vertical wall.
5. Installation
A B
C
.13.