Power Supply Module (Fmps01) - Ametek Gemco 2120 Installation Manual

Spec Tech Industrial Electric

Power Supply Module (FMPS01)

The power supply module has a main power input, an auxiliary input, and a fault check output.
(See Figure 3-4). Power input: 85-265 VAC at 450 mA maximum. Fault check output: 8 amps
250 VAC, 30 VDC, 1/4 HP 125, 250 VAC. It is recommended that the fault check contacts be
connected to the required safety interlock. Auxiliary input: 85-265 VAC at 12 mA maximum.
The terminal wire size for all connectors is No. 22-12 AWG. See page 3, 15 and 16 for use of
this special purpose input, concerning position hold and move detection.
POWER
INPUT
FAULT
CHECK
AUXILIARY
INPUT
Spec Tech Industrial Electric
www.spectechind.com
NO
{
NO
RELAY 1
NC
UPPER LIMIT
NC
NO
{
NO
RELAY 2
NC
LOWER LIMIT
NC
Figure 3-3 Relay Output Pinout Diagram
{
L1
L2
GND
{
NO
NO
{
L1
L2
Figure 3-4 Power Supply Pinout Diagram
Installation and Programming Manual
www.spectechind.com
888-773-2832
Chapter 3: Mounting and Wiring
RELAY
FMOR01
POWER SUPPLY
100-240VAC 50/60Hz
L1
L2
GND
FLT CHK
AUX INP
FMPS01
888-773-2832
11