Appendix A: Error Messages - Ametek Gemco 2120 Installation Manual

Spec Tech Industrial Electric

Appendix A: Error Messages

The Interface Module displays an error message when an error occurs during machine operation.
The format for errors appearing on the monitor's LED display is illustrated in Figure A-1.
Descriptions and solutions for errors are provided in charts A-1 through A-3. Error messages are
grouped into the following three categories:
System Error
Operating Error
Entry Error
NOTE: To clear errors, perform the solutions found in charts A-1, A-2, and A-3. After
completing the solution, press the enter key.
Spec Tech Industrial Electric
www.spectechind.com
This type of error is caused by one of the monitor's modules or
input device. It typically indicates some form of a hardware failure
or problem with the input device. For example, if the input device
is disconnected from the input module, the monitor will display
a system error.
This type of error is caused by problems with typical machine
operation. For example, if the Interface Module does not move
within the time programmed in the Move Detection Time-Out
function, the monitor will display an operating error.
This type of error is caused by an invalid entry through the use of
the monitor's keypad. For example, if an invalid function number
is entered or a value for a function that is out of range is entered,
the monitor will display an entry error.
Chart A-3 Entry Errors
Installation and Programming Manual
www.spectechind.com
888-773-2832
Appendix A: Error Messages
45
888-773-2832