Set Load Balance Function Rules; Show Protocol Status Of Lacp Logical Interface - Yamaha L2 Command Reference Manual

130 | Command Reference | Interface control
port1.17 309
port1.23 186

5.2.10 Set load balance function rules

[Syntax]
port-channel load-balance type
no port-channel loac-balance
[Parameter]
type
[Initial value]
port-channel load-balance src-dst-mac
[Input mode]
global configuration mode
[Description]
Sets rules to specify the forwarding destination interface of the load balance function.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
This command is a system-wide setting.
In the case of a frame that is not an IPv4/IPv6 packet, the forwarding destination interface is determined according to the
forwarding source and destination MAC addresses, regardless of the rules that were specified.
[Example]
With the load balance function, set the system to determine the forwarding destination interface based on the transmission-
source and destination IPv4/IPv6 address.
SWR2311P(config)#port-channel load-balance src-dst-ip

5.2.11 Show protocol status of LACP logical interface

[Syntax]
show etherchannel status [link-id] [summary | detail]
[Keyword]
summary
detail
[Parameter]
link-id
1350 0
186 0
: Rules to specify the forwarding destination interface
type
dst-ip
dst-mac
dst-port
src-dst-ip
src-dst-mac
src-dst-port
src-ip
src-mac
src-port
: Abbreviated display
: Detailed display
: <1-127>
LACP logical interface number
0 0 0
0 0 0
Description
Destination IPv4/IPv6 address
Destination MAC address
Destination TCP/UDP port number
Source and destination IPv4/IPv6 address
Source and destination MAC address
Source and destination TCP/UDP port number
Source IPv4/IPv6 address
Source MAC address
Source TCP/UDP port number