Set Cos Value For Voice Vlan; Set Dscp Value For Voice Vlan - Yamaha L2 Command Reference Manual

If untagged is specified, untagged frames are used as voice traffic.
[Example]
Assign LAN port #1 as voice VLAN to VLAN #100.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#switchport voice vlan 100

6.2.14 Set CoS value for voice VLAN

[Syntax]
switchport voice cos value
no switchport voice cos
[Parameter]
value
[Initial value]
switchport voice cos 5
[Input mode]
interface mode
[Description]
Specify the CoS value to use for voice traffic by the connected device.
The connected device is notified of the setting via LLDP-MED in the following cases.
• Voice VLAN is specified for the corresponding port.
• LLDP-MED transmission and reception is possible for the corresponding port.
[Example]
Set the CoS value to 6 for using LAN port #1 as voice VLAN.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#switchport voice cos 6

6.2.15 Set DSCP value for voice VLAN

[Syntax]
switchport voice dscp value
no switchport voice dscp
[Parameter]
value
[Initial value]
switchport voice dscp 0
[Input mode]
interface mode
[Description]
Specify the DSCP value to use for voice traffic by the connected device.
The connected device is notified of the setting via LLDP-MED in the following cases.
• Voice VLAN is specified for the corresponding port.
• LLDP-MED transmission and reception is possible for the corresponding port.
[Example]
Set the DSCP value to 63 for using LAN port #1 as voice VLAN.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#switchport voice dscp 63
: <0-7>
CoS value to specify for connected device
: <0-63>
DSCP value to specify for connected device
Command Reference | Layer 2 functions | 169