Table of Contents
Advertisement
Before Use
Tube pressure will fluctuate with temperature.
Inflate tubes in sequence to 250 mB/3.6 psi.
Failure to observe this will compromise the
sea-keeping ability and watertight integrity of
the boat. Inflation valves are fitted with quarter-
turn locks to enable rapid deflation.
CAUTION.
Tubes must be inflated in
the correct sequence to prevent
over-inflation.
•
Set valves to shut and inflate tubes evenly,
starting at rear/right, rear/left, then forward
valves.
Safety Check!
WARNING.
ALWAYS attach yourself
to the kill cord when engine is
running. As a precautionary measure before
setting off, always test kill cord functionality by
pulling it away from its switch. The engine
should always stop.
Warning Lights
CAUTION.
Risk of engine damage.
In the event that a warning lamp or
buzzer activates during use, STOP engine
immediately, investigate the cause and/or
contact your authorized Williams Dealer.
16
•
Check bilge for fuel or water contamination.
•
Tighten footwell drain plugs.
•
Ensure towing valve is set in open position.
•
Check engine cover latches are secure.
•
If your tender is fitted with the Auto Bow
Inflate option, ensure that the boat is in
the water with the engine running before
operating the inflator. The inflator has a
high current draw and may excessively
discharge the battery if operated without the
engine running.
WARNING.
NEVER operate the boat
when bathers are using the boarding
ladder, as risk of serious injury exists from the
reverse deflector.
WARNING.
NEVER investigate the
engine bay with the engine running
or ignition on. Ensure the boat is in a
depth of at least 0.95 m/3 ft of water.
Starting Procedure
Sportjet 345, 395 & 435
1 Turn battery isolator on (see page 12).
2 Run bilge blower for 5 minutes.
3 Secure any loose ropes that could get
sucked into the jet unit.
4 Ensure the shift lever is in neutral position.
5 Connect kill cord to switch.
WARNING.
Personal injury may
result if not attached.
6 Turn key to start.
7 Test kill cord for correct functionality
(see Safety Check! section, opposite).
Sportjet 460 & 520
1 Turn key switch to ON position.
2 Run bilge blower for 5 minutes.
3 Secure any loose ropes that could get
sucked into the jet unit.
4 Ensure the shift lever is in neutral position.
5 Connect kill cord to switch.
WARNING.
Personal injury may
result if not attached.
6 Press start/stop button to start engine.
7 Test kill cord for correct functionality
(see Safety Check! section, opposite).
1
2
3
1
Bilge blower switch
2
Bilge pump switch
3
Navigation light switch
3
5
4
6
2
1
1
Battery isolator/ignition key
2
Engine start/stop button
3
Bilge blower switch
4
Music system switch (if fitted)
5
Navigation light switch
6
Bilge pump switch
17
Hide quick links:
Advertisement
Table of Contents
