Table of Contents
Advertisement
WS-AP3660
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a residential and business
environment. This equipment generates, uses, and radiates radio frequency energy, and if not
installed and used in accordance with instructions, may cause harmful interference. However,
there is no guarantee that interference will not occur. If this equipment does cause harmful
interference, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the transmitting antenna.
•
Increase the separation between the equipment or devices.
•
Connect the equipment to an outlet other than the receiver's.
•
Consult a dealer or an experienced radio/TV technician for suggestions.
USA Conformance Standards
This equipment meets the following conformance standards:
Safety
•
UL 60950-1
EMC
•
FCC CFR 47 Part 15, Class B
Radio transceiver
•
CFR 47 Part 15.247, Subpart C (2.4 GHz)
•
CFR 47 Part 15.407, Subpart E (5 GHz)
Other
•
IEEE 802.11a (5 GHz)
•
IEEE 802.11b/g (2.4 GHz)
•
IEEE 802.11n (WS-AP3660)
•
IEEE 802.3af (PoE)
FCC RF Radiation Exposure Statement
The WS-AP3660 complies with FCC RF radiated exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. This device has been tested and has demonstrated compliance when simultaneously
B-2 Regulatory Information
Warning: The WS-AP3660s must be installed and used in strict accordance with the
manufacturer's instructions as described in this guide and related documentation for the device to
which the WS-AP3660 is connected. Any other installation or use of the product violates FCC Part
15 regulations.
This Part 15 radio device operates on a non-interference basis with other devices operating at the
same frequency when using the antennas provided or other Enterasys-certified antennas. Any
changes or modifications to the product not expressly approved by Enterasys could void the user's
authority to operate this device.
For the product available in the USA market, only channels 1 to 11 can be operated. Selection of
other channels in the 2.4 GHz band is not possible.
Hide quick links:
Advertisement
Table of Contents
