Advertisement
•
The
menu, Tamperproof function.
Keypad unlocked FACTORY SETTING – 01
Keypad locked – 00
To change between 00 and 01 simply press the + button
•
The
menu, Programmer Function (Wireless models only).
Thermostat - FACTORY SETTING – 00
Thermostat + Accessory (i.e. window contact MICRO COX) – 01
Thermostat + Programmer – 02
To change between 00 and 02 simply press the + button
NB: None of the settings are permanent and can be changed to your requirements by accessing the advanced menu again and adjusting to your new desired setting.
Wireless Configuration: 23, 24
Remember: the product comes PRE-ASSOCIATED; the following information is in the event that association is lost or configuration is restored to factory settings.
1. On the receiver, press and HOLD the button for 3 seconds, until the LED begins to flash.
23 Receiver
2. On the thermostat, press the MODE button until the display shows the
the + button once to confirm (if performed correctly the receiver should stop flashing at this point) and the MODE button will enable you to exit the association
process.
Additional Information: Receiver Button Functions
Reverse the relay contact (NO/NC)
Delete All Wireless Associations
=
Press and HOLD for 10 seconds (audible click)
=
Press and HOLD for 30 seconds (LED rapid flash & off)
24 Receiver
symbol, then press and hold the + button until the display reads CnF, finally press
Advertisement
