WIRING
REMARKS
⋅ When the hook of the inverter front cover is cut off for wiring, the protective structure (JEM1030) changes to open
type (IP00).
⋅ If the terminal block of the FR-A7NC is removed, built-in terminating resistor can not be used. (Refer to page 11.)
When performing wiring using the space between the inverter front cover and control circuit
terminal block, take care not to subject the cable to stress.
After wiring, wire offcuts must not be left in the inverter. They may cause an error, failure or
malfunction.
18
CAUTION