Syncing Two Bases - Sealy Ease Owner's Manual

syncing two bases (optional)
A Sync Cord is included with the base. Not available on Queen, Full or King/Cal King size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 1
Unplug bases from power source.
STEP 2
Disconnect the Battery Backup Box cable from each Control Box or
splitter cable. Make note where the cable was plugged in.
STEP 3
Connect the male end of each Sync Cord to Control Box or splitter
cable. Insert it into the same port that you disconnected the Battery
Backup Box from in Step 2.
STEP 4
Connect each Battery Backup Box male connection to the sync cord
female connection (Refer to illustration at right).
STEP 5
Plug bases back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both remotes will now
operate both bases simultaneously.
The system is now linked. Buttons pressed on either remote
will control both bases simultaneously.
Control Box 1
Battery
Backup Box 1
PERFORMANCE NOTES
If bases become mismatched, pressing the FLAT button will re-sync the
mechanical positions.
Sync Cord
Control Box 2
Battery
Backup Box 2
13