Installation Diagram; Installation Of The Outdoor Unit - McQuay R08019031289A Installation Manual

Indoor Unit
Front panel
50mm or more from walls
(on both sides)
Air-Purifying Filter with
bacteriostatic virustatic function (2)
Air-Purifying Filter with
bacteriostatic virustatic
function
Filter frame
Outdoor Unit
The outdoor unit must be installed in such a way, so as to
prevent short circuit of the hot discharged air or obstruction
to the smooth air flow. Please follow the installation
clearances shown in the figure. Select the coolest possible
place where intake air temperature is not greater than the
outside air temperature (maximum 45°C).
Installation clearances
Dimension
Minimum Distance,
mm (in) (11.8)
Note: If there is any obstacle higher than 2m, or if there is
any obstruction at the upper part of the unit, please allow
more space than the figure indicated in the above table.
1 IM-WMJ-1207(2)_EN

INSTALLATION DIAGRAM

30mm or more from ceiling
M4 x 12L
Air filter
Opening service lid
Service lid is opening/closing
type.
Opening method
1) Remove the service lid
screws.
2) Pull out the service lid
diagonally down in the
direction of the arrow.
3) Pull down.
Air filter
Tab

INSTALLATION OF THE OUTDOOR UNIT

A B C D
300 1000 300 500
(39.4) (11.8) (19.7)
6
Cut thermal insulation
pipe to an appropriate
Caulk pipe
length and wrap it with
hole gap
tape, making sure that no
with putty.
gap is left in the insulation
pipe's cut line.
Service lid
A
C
1-6
11/20/09, 4:32 PM
Wrap the insulation pipe with
the finishing tape from bottom
to top.
B
D