Basic Operation; Bevel Sanding; Adjustment From Horizontal To Vertical Position - Ryobi BDS4600 Owner's Operating Manual

I
BEVEL SANDING
The worktable can be tilted from
0o
to
45'for
bevel
sanding. Loosen the table lock nut and tilt the worktable
to
desired angle as
shown. Retighten table lock
nut.
WARNING: To
avoid trapping the work or fingers
between the table and sanding surface, the table
should
be
repositioned on the table support to retain
a
maximum of 1.6mm distance between sanding surface
and table.
I6Eglrr?JM.ENr
FRoM HoRrzoNrAL
ro
vERrrcAL
1.
To adjust the sanding belt assembly
f
rom horizontal
to
vertical position insert the allen wrench provided
into
the holes marked horizontal position as shown,
and
turn in an anti clockwise direction until both
screws
inside
the
holes
are loose and the belt assembly can
move.
2.
Move
the belt assembly arm to the vertical position
as
shown.
3.
To lock
the sanding belt assembly arm in the
vertical
position insert
the allen wrench into the holes
marked
vertical position (as shown) and turn the two
scre\^,/s
inside
the holes in
a
clockwise dtrection until tight
BASIC OPERATION
Fig20
Worktable
Fig21