Table of Contents
Advertisement
Hardware Preparation and Installation
Installation Procedure
Read all notices and follow these steps to install a PMC on the baseboard.
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or shorten
their life.
Before touching the board or electronic components, make sure that you are working in an ESD-
safe environment.
Product Damage
Inserting or removing modules with power applied may result in damage to module
components.
Before installing or removing additional devices or modules, read the documentation that came
with the product.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the
chassis as a ground. The ESD strap must be secured to your wrist and to ground
throughout the procedure.
2. Remove the PCI filler from the front panel.
3. Slide the edge connector of the PMC module into the front panel opening from
behind and place the PMC module on top of the baseboard. The four connectors on
the underside of the PMC module should then connect smoothly with the
corresponding connectors on the MVME7100.
4. Insert the four short phillips-head screws (provided with the PMC) through the
holes on the bottom side of the MVME7100 and the PMC front bezel and into rear
standoffs. Tighten the screws. Refer to
5. Reinstall the MVME7100 assembly in its proper card slot. Be sure the module is well
seated in the backplane connectors. Do not damage or bend connector pins.
42
Figure 2-6 on page
MVME7100 Single Board Computer Installation and Use (6806800E08C)
43.
Advertisement
Table of Contents
