Advertisement
Quick Links
Safe and Silent Solutions
for Roller Shades
SMARTROLL™ 32-1
INSTALLATION INSTRUCTIONS
Roller Shades
INSTALLATION INSTRUCTIONS ~ SMARTROLL™ 32-1
Thank you for purchasing your new Smartroll shades. They
have been custom-made from the highest quality materials
to the dimensions you specified. With the proper installation
and care, it will provide you with many years of beauty and
trouble-free use.
Please read all instructions before you start so you will be
familiar with the overall process.
Make sure you measure your window to ensure the shade
will fit properly before beginning.
Getting Started
Remove the Smartroll shades from the packaging. Keep the
packaging until you have successfully installed the shades.
TOOLS REQUIRED
• Pencil
• Power Drill with the following bits:
• Awl
- ¹⁄₁₆" Drill Bit
• Tape Measure
- ¹⁄₄" Hex Driver
• Level
- Standard Screwdriver
• Ladder or Stepstool
- Masonry Drill Bit (if drilling into
FASTENER NOTES
For outside mount, it is best to attach the bracket to wood
studs. If this is not possible, you will need to purchase special
fasteners (see illustration below for examples).
Molly Bolt
Hollow Wall Anchor
Here are some HELPFUL TIPS:
• If you are using a special fastener, make sure it is
designed to support the weight of the shades. Follow the
fastener manufacturer's instructions carefully.
• When drilling into drywall or plaster, use a fastener
designed for hollow wall applications (see illustration).
• When drilling into concrete, stone, brick, or tile, use
appropriate plugs, anchors, or screws (not included).
• When drilling into metal, the included screws are sufficient.
Pre-drill ¹⁄₈" holes.
concrete or brick)
Anchor
Advertisement
Summary of Contents for Fabritec designs Smartroll 32-1
-
Page 1: Getting Started
Roller Shades INSTALLATION INSTRUCTIONS ~ SMARTROLL™ 32-1 Thank you for purchasing your new Smartroll shades. They have been custom-made from the highest quality materials to the dimensions you specified. With the proper installation and care, it will provide you with many years of beauty and trouble-free use. - Page 2 BEFORE YOU BEGIN, VERIFY THAT YOU HAVE ALL THE NECESSARY Mounting the Shades PARTS AND PIECES: STEP 1 - BRACKET INSTALLATION. • SHADES - NOTE THE SHADE SIZE. THIS IS VERY IMPORTANT. Attach the brackets to the wall. Use a pencil to mark the drilling points and a level to keep a proper horizontal For shade sizes less than 36⁷⁄₈”...
- Page 3 STEP 2 - ROLLER SHADE INSTALLATION (continued). STEP 3 - ADJUST THE SHADE SPEED (continued). Note: There is a flat surface on the wheel to help in counting of the revolutions. If the tension is too tight, lift the right pin only out of the bracket, and the tension will release.
- Page 4 STEP 5 - ALIGN THE HOLES. Operating your Smartroll Shades There are 5 holes at the end of the brake wheel. Rotate the Unlike the typical spring shade, a Smartroll shade requires a shade until the holes line up with the holes on the bracket. minimal ¹⁄₄”...