Speaker Connections And "Speaker Setup" Settings - Pioneer VSX-LX503 Instruction Manual

Speaker Connections and "Speaker Setup" Settings

Connections
„ (Note) Speaker Impedance
Connect speakers with an impedance of 4 Ω to 16 Ω. If any of the speakers
to be connected has an impedance of 4 Ω or more and 6 Ω or less, the setting
is required in the System Setup menu after the Initial Setup (
completed. Press on the remote controller, and in the Home displayed set
"System Setup" - "Speaker" -"Configuration" - "Speaker Impedance" to "4ohms".
„ Connect the Speaker Cables
1/2˝
(12 mm)
Contents Connections
≫
Make correct connection between the unit's jacks and speaker's jacks (+ side to
+ side, and - side to - side) for each channel. If the connection is wrong, a bass
sound will not be reproduced properly due to reverse phase. Twist the wires
exposed from the tip of the speaker cable so that the wires do not stick out of the
speaker terminal when connecting. If the exposed wires touch the rear panel,
or the + side and – side wires touch each other, the protection circuit will be
p155) is
activated.
40
Playback
≫
Front Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫