Table of Contents
Advertisement
PC 6170 User's Manual
BUTTON-ONLY
Follows the conventional way of turning OFF system
power (via power button).
Upon selecting this option, the K B POWER ON
Password line appears. Press <E nter> and you'll be
prompted to enter and confi rm a password of your
Password
choi ce.
After setting the password, succeeding attempts to
power ON the system will result to null. For system to
acti vate, user must input the password via keyboard
then press <Enter>.
This option i s very similar with that of P assword.
Hot KEY
Hot-key combi nations range from Ctrl -F1 to Ctrl -F12.
User m ay define this combination from the Hot key
Power ON opti on.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install and-in FDC or
the system has no floppy drive, select Disabled in this field. The options
available are Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports. The options available are 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4,
2F8/IRQ3, Disabled, Auto.
UART2 Duplex Mode
The second serial port offers these infrared interface modes:
IrDA
9
ASKIR IrDA-compliant serial infrared port
9
Normal (default value)
9
NOTE:
The UART Mode Select will not appear on the menu
once you disable the setting of Onboard Serial Port 2.
When UART Mode Select is set as ASKIR or IrDA, the options RxD, TxD
Active and IR Transmittion delay will appear.
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal unless your hardware and software require one of the other
modes offered in this field. The options available are EPP1.9, ECP, SPP,
ECPEPP1.7, and EPP1.7.
50
SBC83810 BIOS Setup
Advertisement
Table of Contents
