Connecting The Power Pack - Nissin MG10 Instruction Manual

External Power Pack Socket (sell separately)
Make sure to switch o� f f both the Power Pack and the
!
flash unit before use.

Connecting the Power Pack

1.
Use the compatible flash power supply cable for MG10.
Hold the connector of the flash power supply cable
in front of the socket with both guide marks on the
connector and on the socket coinciding and insert
it into the socket straightly. You can plug the
connector into either socket 1 or socket 2.
2.
Connect the plug at the other end of the power
supply cable to the MG10.
Disconnecting Power Supply Cable
1.
Make sure the Power Pack has been switched OFF.
2.
Hold the connector of the flash powter supply
cable as shown and pull it off.
21