Nissin MG10 Instruction Manual page 15

Hide thumbs Also See for MG10:

Table of Contents

Flash Exposure Control

All the following setting have to be carried out on the control of the

commander order on the commander Air 10s.

M manual flash mode power control

1. Press the Group Selection button, the group letter blinks.

2. Rotate the Operation Dial to increase or decrease the flash power of the group selected.

The setting of M mode on Air 10s starts from 1/256 (minimum) to 1/1 (Full), and

controlled by 1/3 step intervals. The value digi displayed next to the group

only shows the integer step value ( * ) .

M mode

3. When the M mode setting is completed, press the group selection button again.

(*) The integer step values of Nissin Air 10s are

1/1, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64, 1/128 and 1/256

CAUTIONS

If you do not press any group selection button which means all group letters in the

display do not blink,

groups. For example, A: 1/256, B: 1/8 + 0.6EV, C: 1/4, D: 1/2, do not select any

group then rotate the Operation Dial clockwise with 2 intervals, it becomes

A: 1/256 + 0.6EV , B: 1/4 + 0.3EV, C: 1/4 + 0.6EV, D: 1/2 + 0.6EV.

rotate the Operation Dial to increase/ decrease the power of all

Table of Contents