Gear Delay Options - Glendinning EEC4 Installation Manual

Gear Delay Options

The Gear Delay Option allows you to configure the EEC system to remain in gear when the system
goes from the throttle range to neutral, to allow throttle to reach idle before shifting transmission.
Neutral
Throttle
range
Moving handles from the
throttle range (above idle)
into neutral . . .
Throttle
range
RPMs decrease to idle . . .
To Change Gear Delay Setting Follow These Steps:
ACTION
Press ACTIVE
5 times for
Gear Delay
Option
Press
WARM to
activate
selection
Press &
Release
ACTIVE
to cycle
through Gear
Delay Options
Press
WARM to
save option
selection
Section 2.0 — Appendix / Reference
Configurable
0-2.5 second
Delay
while transmission
pauses . . .
(Default = 0 seconds)
Enter Configuration Mode as described in section 2.4A (pg. 29)
1
Port Neutral
2
3
Port Neutral & Active
4
5
Port Neutral & Warm
6
You may continue to other configuration options
on the following pages or you may choose to
EXIT CONFIGURATION MODE by turning
system OFF, moving control handles back to
NEUTRAL, and then turn system ON again.
before shifting transmission
RESULT
WARM LED will begin to flash
NO LEDs will be illuminated
LEDs ON AMOUNT OF DELAY
None
Active
Warm
29
into Neutral.
None (Default)
0.5 second
1.0 second
1.5 second
2.0 second
2.5 second