Glendinning EEC4 Installation Manual page 13

IMPORTANT — When routing and connecting the throttle and gear harness, BE SURE TO:
Insert the plug completely into the receptacle on the control processor and the engine. You
should hear a "click" when the plug is fully inserted.
DO NOT route cables past any sharp edges!
See the photos below and on the next page for step-by-step instructions for connecting the
Control System Enable connections.
ENGINE
CONNECTION
Control Connect the 4 pin control system enable plug to the
System appropriate connection on the vessel adapter harness. In
Enable order to do this you will need to follow the steps below:
Locate control system plug from
1
engine
keyswitch
jumper
breakout
Cut & remove heat shrink
2
tubing
keyswitch
jumper
breakout
Remove existing jumper from
3
engine side connector
existing keyswitch
jumper breakout
DESCRIPTION
remove jumper
Section 1.0 — Installing the EEC4
ILLUSTRATION
control system
enable plug
to vessel
adapter harness
to vessel
adapter harness
to vessel
adapter harness
9
piggy-back
connector